What a pass-thru device does
Before J2534, reprogramming a module meant owning each maker's own interface box. J2534 split the job in two. The maker writes the software and sells access to it. Anybody may build the box, as long as it answers a fixed set of calls: open, connect, set a filter, write messages, read messages.
The maker's software does not know or care whose box it is talking to. That is the whole point, and it is also what makes a remote version possible: the calls can be answered by a driver that passes them on to a box somewhere else.
Three ways to do J2534 from a distance
They differ in what has to be at the car.
- A computer at the car, driven by remote desktop. The software, its licence and the interface all sit beside the vehicle. It works with everything, including DoIP, and it needs a computer and somebody able to set it up.
- A pass-thru interface at the car, software at your shop. The maker's software runs on your own computer and a driver carries each J2534 call to an interface plugged into the car. This is what IgniteRemote tool sharing does today.
- The box as the interface. The same, with no computer at the car at all: AirModuleLink is designed to answer the J2534 calls itself.
Why it is hard to stretch
The maker's software was written for a cable. It sends a request and expects the answer within tens of milliseconds, it sends a keep-alive on a schedule, and during a download it expects each block acknowledged in time. Every one of those now crosses the internet twice.
A remote J2534 link therefore has to do two things a cable never had to: keep the time-critical parts of the conversation close to the car, and refuse to begin a programming sequence over a connection that is not good enough to finish it.
Versions 04.04 and 05.00
Most maker software loads a version 04.04 driver. Version 05.00 changed how devices are found and how messages are queued, and some newer software asks for it by name. A driver that only speaks 04.04 simply does not appear in that software's list of interfaces.
What AirModuleLink does with it
The IgniteRemote J2534 link carries the maker's software on your computer to the car, and has been used on real vehicles with the software listed below. AirModuleLink is designed to be the interface at the car itself, and its Tool Tunnel covers the standalone tools that are not J2534 software.